* Only the single-pack of the LBE-5AC-Gen2 includes a PoE adapter. Antenna types not included in this list or having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. This radio transmitter FCC ID: SWX-LBE5ACG2 / IC: 6545A-LBE5ACG2 has been approved by FCC / ISED Canada to operate with the antenna types listed below with the maximum permissible gain for each antenna type indicated. Output power is adjusted to compensate for loss between the radio and the antenna. Cable Loss (When applicable)Įnter the cable loss in dB. Note the requirements and antenna types listed below. For a Custom antenna, Antenna Gain is entered manually. If Calculate EIRP Limit is enabled, transmit output power is automatically adjusted to comply with the regulations of the applicable country. WARNING: The switch port must comply with the power specifications listed in this Quick Start Guide.Īccessing airOS via Wi-Fi Installer Compliance Responsibilityĭevices must be professionally installed and it is the professional installer's responsibility to make sure the device is operated within local country regulatory requirements. This port should be connected to the LAN and DHCP server. ![]() Supports 10/100/1000 connections and passive PoE. The LiteBeam AC may also be reset remotely using the auxiliary Reset button located on the bottom of the Gigabit PoE adapter. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the LiteBeam AC is powered on. The LED will light blue when the device is connected to a power source. The LED will light steady blue when an active Ethernet connection is made and flash when there is activity. The RocketPrism 5AC Gen 2 features both airMAX ac. The LiteBeam AC mounted outdoors without the reflector installed provides outdoor-to-indoor coverage using the 3 dBi Antenna Feed only. Ubiquiti Networks has designed airMAX ac radios with high performance and ease of installation in mind. ![]() The LiteBeam AC mounted outdoors with the reflector installed provides directional outdoor coverage (gain reflector-dependent). The ETH-SP will absorb power surges and safely discharge them into the ground. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the LiteBeam and the other at the entry point to the building. Surge protection should be used for all outdoor installations. ![]() For more details, visit ui.com/toughcable We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.
0 Comments
Leave a Reply. |